Settings

Language

Currency

Country

Wishlist 0

0 0,00 €

Suvi

Rowing-Palta 605 Keel iron 20 mm Grille (Not including installation)

Name: Rowing-Palta 605 Keel iron 20 mm Grille (Not including installation)
Brand: Suvi
Price: 173.38709677419 EUR
Availability: InStock

215,00 €

Keel iron for Suvi and Palta boats, where you can put a 30 mm wide keel iron.

Product serial: SIR106 Product in stock

Amount

Soutu-Palta 605

Keel iron for Suvi and Palta boats, also suitable for other brands of fiberglass boats equipped with sand resin keels.

- plate 30 mm

- length xx

The necessary screws for fastening are included.

Installation requires good craftsmanship and a clean, dry installation location. The necessary sanding materials and structural glue are not included with the keel iron. Short installation guide below.

Recommended for these Suvi boats:

- Soutu-Palta 605

Some of Suvi's original accessories are delivered directly from the factory, delivery time 3-5 days.

Installation of the keel of Suvi and Palta boats:

You will need:

Keel iron 1 pc (drilled holes ready)

Putty, e.g. Sikaflex 221

Pulp press

Acid-resistant screws 3.5 x 16 or 19 mm (included)

Drill

Stone drill bit 3.3 mm

1. Clean the keel area of dirt and dry well

2. Apply the mass with a mass press to the keel and below the keel iron. Press the keel iron firmly into the mass.

3. Attach the keel iron starting from the stern with acid-resistant screws. Use a stone drill bit to drill a pilot hole for the screw (a hole the length of the screw).

Before attaching the screw, make sure that the strip is attached to the keel all the way. Put the compound in the screw holes as well.

4. Finally, extrude the edges of the keel iron with mass to ensure a neat end result.

5. Let dry for 24 h

NOTE!

The boat's keel must be clean and dry, and the temperature must be the same

at least +15 °C while the pulp dries (about 24 hours).